NAD Integrated Amplifier with MDC BluOS-2i card installed

Category:

No tags found

Description

NAD C298 | Stereo Power Amplifier

Weight & Dimensions

  • Gross Dimensions (W x H x D)*435 x 100 x 390mm (17 1/8 x 3 15/16 x 15 3/8)”
  • Net Weight: 7.8kg (17.2lb)
  • Shipping Weight: 10.1kg (22.3lb)

    Power Consumption

  • at Auto Standby ON and Network Standby OFF0.5 Watts*
  • at Auto Standby ON and Network Standby ON1.2 Watts**
  • OFF mode (Power switched OFF)0.1 Watts

    General Specifications

  • Continuous Output Power into 4 Ohms and 8 Ohms (Stereo)>80W (ref. 20-20kHz at rated THD, both channels driven)
  • Continuous Output Power into 8 Ohms (Bridge Mode)300W (at 20-20kHz at THD 0.03%)
  • THD (20Hz-20kHz): <0.03% (250mW to 80W, 8 Ohms and 4 Ohms)
  • Signal to Noise Ratio: >98dB (A-weighted, 500mV input, ref. 1W out in 8 Ohms)
  • Clipping Power: >95W (at 1kHz 0.1% THD)
  • Clipping Power (Bridge Mode): >315W (at 1kHz 0.1% THD)
  • IHF Dynamic Power
      • 8 Ohms 120W
      • 4 Ohms 200W
      2 Ohms 250W
  • IHF Dynamic Power (Bridge Mode)
      • 8 Ohms 500W
      4 Ohms 560W
  • Peak Output Current: >20A (in 1 Ohm, 1ms)
  • Damping Factor: >300 (ref. 8 Ohms, 20Hz and 6.5kHz)
  • Frequency Response: ±0.3dB (20Hz-20kHz)
  • Channel Separation: >75dB (1kHz), >70dB (10kHz)
  • Input Sensitivity (for 80W in 8 Ohms)Line In: 470mV; Digital In: 21% FS
  • Sample Rate: up to 24 bit/192kHz
  • Frequency Band: 2.402G-2.480G
  • Maximum Transmit Power (dBm): 7dBm ±2dBm

    Preamplifier – Line Input, Pre Out

  • THD (20Hz-20kHz): <0.005% at 2V out
  • Signal/Noise Ratio: >106dB (IHF; A-weighted, ref. 500mV out, unity gain)
  • Channel Separation: >80dB (1kHz); >70dB (10kHz)
  • Input Impedance (R and C): 22 kilohm + 100pF
  • Maximum Input Signal: >4.5Vrms (ref. 0.1% THD)
  • Output Impedance: Source Z + 240 Ohm
  • Input Sensitivity: 93mV (ref. 500mV out, Volume maximum)
  • Frequency Response: ±0.03dB (20Hz-20kHz)
  • Maximum voltage output – IHF load: >4.5V (ref. 0.1% THD)
  • Tone Controls:
      • Treble: ±7.0dB at 20kHz
      • Bass: ±7.0dB at 60Hz
      Balance: -10dB

 

Reviews

There are no reviews yet.

Be the first to review “NAD Integrated Amplifier with MDC BluOS-2i card installed”

Your email address will not be published. Required fields are marked *